Full MEP Engineering for Container Home in Phoenix, IL

I am finalizing the design of a 1,900 sq ft, three-bedroom, two-bath all-electric container home and now need complete Mechanical, Electrical, and Plumbing engineering so the plans are ready for permit submission and construction. The project is located in Phoenix, IL. Mechanical – Lay out a duct-free heat-pump mini-split system sized to the envelope and climate zone, including line-sets, condensate routing, and required clearances. – Design the ventilation and exhaust strategy (kitchen, baths, laundry) to meet code while avoiding additional ductwork in living areas. – Specify and locate an electric tankless water heater with all supporting details. Electrical – Provide an all-electric wiring plan, panel schedule, and load calculations. – Show PV-ready provisions: dedicated breaker space, conduit paths, and combiner/interconnection notes. – Include dedicated circuits and hookups for the washer and dryer. Plumbing – Produce supply, waste, and vent diagrams sized for simultaneous demand of two bathrooms, kitchen, and laundry. – Coordinate hot-water distribution from the tankless unit for minimal lag. Deliverables • Signed/sealed MEP drawings in PDF and DWG (or equivalent CAD) formats suitable for permit. • Equipment schedules, calculations, and any code compliance notes required by the local authority. • Multiple rounds of revisions after initial plan-check comments. Let me know your anticipated timeline, the codes/standards you work to, and any information you still need from me so we can move this project forward quickly. I have attached basic plans and elevations. Plumbing fixtures are not shown.

Project ID: 40424077