Đang Thực Hiện

DSPIC33EP256MU806 Modules using MPLAB-X IDE

Dear all ,

I need the following modules for DSPIC33EP256MU806 ,

-UART module with good structure (will be explained below, )

-RTCC module which gives me the current date & time

-Delay functions built it 1 ms , 1 us , ...etc

-Different clocking system module (External - Internal with PLL & Comments to value of clock)

The system will run on External 60 MHZ clock , you should provide to me the right configurations for this like OCCR= ... etc & It also should be flexible to run on any clock .

All modules should be written using MPLAB-X IDE , Please if you aren't familiar with it don't bid...!

An Example of good structure(.h& .c) :- Assume I've a LED port to turn a LED on or OFF on portb , pin 1



#define LEDPIN 1

//Setting the direction of the port

LEDTRIS &= ~(1<<LEDPIN) ; // Setting it to be ouput

//Turning on the LED

LEDPORT |= (1<<LEDPIN); //Setting the pin

& so on ...

Try to be follow the above system in the structure of PINS specially remappable pins.

Any further explanations don't hesitate to ask me .

I need this job to be done within the next 24 hours.

Please type the word " ECHO" in reverse in your bid to make sure that you read the specification & you aren't a BOT.

Kĩ năng: Lập trình C, Kĩ thuật điện, Điện tử, Phần mềm cài sẵn, Vi điều khiển

Xem nhiều hơn: dspic33ep256mu806, programming ide, programming define, programming comments, job define, ide specification, ide programming, ide for programming, ide for c programming, define structure, define programming, define job, define c programming, c programming ide, c programming define, mplab, dsPIC, built using, programming electronics, external internal, follow bot, ide clock, pin bot, programming led, need bot built

Về Bên Thuê:
( 1 Nhận xét ) Cairo, Egypt

ID dự án: #1635200

2 freelancer đang chào giá trung bình $90 cho công việc này


hi i can do it thanks

$80 USD trong 1 ngày
(34 Nhận xét)

Hi, Please see the PMB

$100 USD trong 7 ngày
(0 Nhận xét)