Đang Thực Hiện

Arduino Mega to GSM GPS RFID

Need a programmer to generate a code to get the uplaod of GPS data thru GPRS at a set interval, configured by sms and TCP (Gprs). Also to save each data in SD card. When RF card is shown to RFID it should upload the data captured with GPS time thru gprs. also save each data to sd card with a serial number and if instructed device should send the backlog data thru gprs.

Sms command: IP and Port, Time interval, APN, Identity of device, turn digital pin high/low

Gprs packet :imei, gprmc,with 5 Digital input pin status and 2 Analog pin

I have the Arduino Mega Board with GSM 900a modem and GPS with RFID. You need to give me connectivity diagram and with source of the project as required above.

Experience in Arduino will be preferred, also with time faster

Kĩ năng: Lập trình C, Phần mềm cài sẵn, Kĩ thuật

Xem nhiều hơn: rfid gps arduino, arduino gps project, gsm rfid arduino, arduino mega rfid, arduino mega gps, arduino rfid sms, arduino gps rfid, serial port programming, programming diagram, programming arduino in c, need arduino programmer, low connectivity, get gps by sms, get arduino, arduino c programming, sms gsm, rfid, need rfid programmer, modem sms c++, mega, imei, GSM, gsm modem, gsm gps, gsm arduino

Về Bên Thuê:
( 40 nhận xét ) New Delhi, India

ID dự án: #4546393

Được trao cho:


Hello, Having looked at the brief project requirements, I think I can take this up. This is because I have got prior experience in handling Arduino boards with ATMega328 and I have also worked on a few 8, 16 and 32 Thêm

$166 USD trong 6 ngày
(0 Đánh Giá)

2 freelancer đang chào giá trung bình $305 cho công việc này


Hello, we're interested. We've provided similar solution. Pls. check PM for details. Thanks.

$444 USD trong 15 ngày
(6 Nhận xét)