Đã Trao

Điện tử Job by chamtech

Hi Botond

We are interested in FPGA development. Our requirement is to take in a video stream in either DVI or HDMI. To decode the video data into RGB

values and scale the value of each with an 8 bit value.

This brightness value will be supplied on a 3 line interface consisting of clock,

data and update. The data is 24 bits shifted in on the rising edge of the clock line,

after all 24 bits are clocked in the update will pulse low.

After doing the scaling the RGB video data is then recombined with the control bits

(delayed if needed to account for scaling time) and then reassembled into

either HDMI or DVI.

A control pin will configure operation mode, low for HDMI and high for DVI.

Xilinx FPGA preferred ideally with internal configuration memory ....the XC3S50AN

would be the sort of part. Not sure if you can get the double data rate to

work in this part. Could be a BGA part if needed.

There will also be a few bits of logic which will be suppied as a circuit diagram.

This should be less than 20 flipflops and 30 gates using

about 8 i/o pins and running about 300KHz.

The design will need to support the six common formats of video screen formats....

as per Xilinx application note XAPP460 Table 2 on page 1.

The project is not urgent. We would produce a test PCB when you have a device

selected and a firm design. We would ship this to you for testing.

This is a provisional specification.

Please let me know if this project would be of interest to you.

Best regards

George McDuff

Kỹ năng: Điện tử

Xem thêm: specification requirement, specification of requirement, requirement and specification, may 2, low bits, gates application, bits of, bit operation, bit bits, application requirement specification, all the bits, all bits, 3 line diagram, xilinx, rgb, pins and, pcb testing, pcb development, internal project, HDMI, george, dvi, operation video, need work low project, control pin

Về Bên Thuê:
( 0 nhận xét ) United Kingdom

Mã Dự Án: #1623519