I have invented a product that has been accepted for presentation on a television show. Unfortunately, they have only just contacted me and I have until Monday, May 2 to try to get this to them and actually that's pushing it so I truly apologize for the short notice.
VACCUUM DATA - I have already constructed the invention itself but I need someone who can make a small vaccuum source with minimal suction power and minimal noise. The vaccuum source should be no larger than 4" long, 3" wide and 3" high. It will simply be attached to a plastic bag and draw product into the bag. The suction hole should not be big enough of itself inhale anything, it is only to provide suction, so a very small vented screen should be placed over it.
ELECTRONIC DATA - I also need someone who can create a power source that will hold eight 4" long bars, attached to two 10" long bars and ajoined by two 4" long bars. Four of the 4" long bars on each of the two 10" long bars in two sets of two, approximately a 1/2" apart with a 1/2" fitting ball that rolls up and down between each set of two. The two sets of 1/2" bars should also be able to move back and forth simultaneously while moving up and down.
I prefer everything be made out of plastic for lightness purposes. Both of these items can be connected to the same power source but need to have preferably a re-chargable battery power source and absolutely need to have individual power buttons to be used either together or individually.
This is a prototype only. Obviously, if the television show buys this product and they will, we are looking at incalculable income and sole contract rights for the person(s) who does this for me. I am only the inventor, I apologize for my unprofessional verbiage in these descriptions and I hope you understand.
In synopsis, ten plastic bars two sets of two short bars housing a small plastic ball, on one of the long bars which will be held together at each end with two additional bars for a total of 6 short bars. Four small plastic balls roll up and down and the bars housing the balls move back and forth simultaneously. each side in sets of 2 attached to each other with a ball that moves up and down and back and forth in the middle and the mild vaccuum source sucks gently through already existing tubing into a bag.
Please bid a.s.a.p as this will be quite the job in a very short period of time. Thank you