Repair Morgana FRN5 Motor

@Ryan15222

Hi, I am interested in helping diagnose and repair your Morgana FRN5 numbering/perforating machine. As an engineer with experience in industrial equipment, electrical troubleshooting, motor control systems, and machine diagnostics, I can systematically investigate the root cause of the motor failure and identify the most cost-effective repair solution. Since the power supply, fuses, breakers, and motor connections have already been checked, the fault may lie within one of the following areas: • Motor starter, relay, or contactor failure • Control PCB or motor drive circuitry • Emergency stop or safety interlock circuits • Limit switches or position sensors • Faulty motor capacitor (if applicable) • Internal motor winding or thermal protection fault • Control transformer or low-voltage control supply issues My approach includes: • Review of machine schematics and service documentation • Guided electrical troubleshooting and fault isolation • Voltage and continuity checks at key test points • Motor and control circuit evaluation • Identification of failed components and repair recommendations • Support during testing and recommissioning To begin, I would need: • Photos of the electrical cabinet and control boards • Machine model/serial information • Any wiring diagrams or manuals available • Description of machine behavior when Start is pressed (lights, sounds, relay clicks, etc.) Best regards,