Rx cylindrical coil for wireless charging system

Đã Đóng Đã đăng vào 1 năm trước Thanh toán khi bàn giao
Đã Đóng Thanh toán khi bàn giao

I need to build cylindrical coil for RX receiver of a wireless charging system and define the TX receiver coil with main chip controller in TX and RX section.

It is not important for me the electric schematic of this project because I can made myself but I need to define commercial chip to do this application

For the TX there are not problems because I have 15x8cm of surface size.

The problem is for RX receiver because I need to use a diy cylindrical coil.

Maximum dimensions for this coil are 22mm of diameter and 45mm of lenght with 5W of power.

This coil has to be in air.

Điện tử Kĩ thuật điện Kĩ thuật cơ khí Kĩ thuật Thiết kế sản phẩm

ID dự án: #33669072

Về dự án

7 đề xuất Dự án từ xa 1 năm trước đang mở

7 freelancer chào giá trung bình$450 cho công việc này

sajjadtaghvaeifr

Hi, I hope you are doing fine. I have PhD in mechanical engineering from Tohoku University of Japan. I have published 20 Journal papers and 16 international conference papers. I have a lot of experience in automotive, Thêm

$750 USD trong 7 ngày
(83 Nhận xét)
6.6
etalhak

Hello, I am an electronics and telecommunication engineer and my major is wireless systems' design. I am experienced in hardware and embedded systems' design. I have designed/printed/tested many PCBs and I am quite exp Thêm

$250 USD trong 7 ngày
(44 Nhận xét)
5.5
youhana167

Mechanical Engineer Expert Hi there, I will do this project according to your concepts and requirements. I would share previous work and samples with you. I would give high quality work and results. I’m professional m Thêm

$250 USD trong 7 ngày
(24 Nhận xét)
4.8