I am working on automating my air conditioner by reading the signals from the Remote, which i would like to then send out later to turn the AC on and off.
I have the following setup:
- Raspberry Pi 4B
- VS1838B Infrared receiver
- 5mm 940nm IR infrared Emission
(along with other require items)
- hitachi remote rar-3n5-1
The problem is i am not getting any readings on the ir receiver device.
I would like to do the following:
- Read Remote signals
- Check room temperature using sensor (this sensor is working)
- Send on & off signal based on temperature
I can provide more info on chat