Đang Thực Hiện

remote control knob (wired)

Hello:

I have a TIG welder that is low-end. It has current control only on the power source with no option to connect a remote control (pedal or torch knob) like higher end models do.

I am interested in having a small wired remote control knob that can attach to the torch handle and would allow me to adjust the current up or down back at the power source.

I am mechanically inclined but am a novice at reading electrical diagrams. Project would entail blue print and instructions. All parts should be easily acquired (standard).

Edit 1: The knob must have some resistance on it to prevent accidental current change during torch usage. A very smooth easy to move knob would not be good. Perhaps indexed.

Kỹ năng: Điện tử

Xem thêm: power up reading, novice novice, i control, remote power, print models, pedal, control, electrical small project, small electrical project, power control, knob, remote control source, electronics small project, source control, project electrical, electrical power control, wired remote knob, knob control flash, remote project, novice, control remote pc, BLUE PRINT, skype control remote, ajax knob control, wired ipod control

Về Bên Thuê:
( 0 nhận xét ) Seattle, United States

Mã Dự Án: #1020080

3 freelancer đang chào giá trung bình $133 cho công việc này

IoliteTech

Hi, Please Check PM.

$50 USD trong 5 ngày
(2 Đánh Giá)
1.7
bkalaska

I can do this. I was the supervisor for the welding shop at Incat Catemerans in Tasmania, Australia. Have done this kind of thing a lot of times. Will need make and model of your welder. I will supply wired potentiomet Thêm

$100 USD trong 7 ngày
(0 Đánh Giá)
0.0
rbettes

I have extensive experiance in designing spot weld controllers/timers which can work in standard mode or constant current. Regards Roy

$250 USD trong 30 ngày
(0 Đánh Giá)
0.0