I'm working on product development for my startup and require 30 accelerometers in order to track a lot of precise movement. For the prototype I am using the MPU-6050 on the GY-521 breakout board, but realized that the SDA/SCL pull-up resistors are far too low. I'm wiring the boards in parallel, so the resistor values need to be 30x higher. The attached JPG shows which resistors I'm talking about. The schematic in the attached PNG shows 4.7kOhm, but the R4/R5 resistors on the boards are 2.2kOhm for some reason. I can provide 143kOhm SMD resistors and all the breakout boards, I just need someone to swap out the resistors for me.
19 freelancer đang chào giá trung bình $114 cho công việc này
HI I am experienced electronics engineer with more than 15 years of experience. I have read the details and would like to know more about it Please get in touch to discuss it further Regards
Dear Contest Holder, The project you wants to do. I did similar project yet. I can help you in this project. Please send me a private message so that we can discuss further more. Thank you.
I am familiar with your project. So I will complete your project on time and with perfection. I know both the software Eagle and Altium for the PCB design
i can able to swap the SMD resistor. i have 10 years exp in this pcb assembly field. i have trained for IPC A 610 G. as per the IPC standard i will swap the component.