Đã Hủy

Zigbee CC2530 (Texas Instruments) - Setup basic mesh communication

Hello,

I bought three CC2530 modules:

[url removed, login to view]

One development board:

[url removed, login to view]

Three USB explorer boards:

[url removed, login to view]

And original CC debugger:

[url removed, login to view]

-----------------------------------------------------------------------------------------

Here is what I need:

I don't want to use 8051 MCU on the Zigbee board (as MCU with my program I will use Arduino Uno board) so I want to use the Zigbee just as wireless network processor allowing me to create mesh communication with one coordinator and two end nodes. Arduino then will be setting DH and DL adresses of the Zigbee and sending messages with sensor monitoring etc.

I have successfully uploaded ZNP firmware with bootloader to the Zigbee through SmartRF Flash Programmer but I am not sure if that is the correct one for my purpose. I also have IAR Workbench downloaded for compiling my own firmware but I heard it's not necessary when I don't want to use MCU on the Zigbee board.

The problem is that when I want to open the Zigbee through COM terminal and send "+++" to configure the Zigbee (Coordinator role, DH, DL, PAN ID etc.), Zigbee does NOT respond with "OK". I have tried all the possible combinations of baudrate etc but cannot make it work.

I also have Xbee S2 programmed with Zigbee TH firmware and when I open this Xbee in the COM terminal program and write "+++" it responds with "OK".

How can I achieve this with Zigbee?

Kỹ năng: Arduino, Điện tử, Phần mềm cài sẵn, Vi điều khiển, Không dây

Xem thêm: basic mesh character, simulation control monitoring visual basic serial communication proteus, texas instruments j2ee, calypso texas instruments module, efi texas instruments dsp, visual basic serial communication, texas instruments rtc i2c design, texas instruments bms, use webmin setup basic iptable ubuntu, pcsc linux texas instruments, texas instruments bms lithium, general ledgers texas instruments, texas instruments philippines duties responsibilities, texas hold visual basic, texas holdem visual basic

Về Bên Thuê:
( 2 nhận xét ) Rohatec, Czech Republic

Mã Dự Án: #15835220

6 freelancer đang chào giá trung bình €151 cho công việc này

€50 EUR trong 1 ngày
(6 Đánh Giá)
3.7
jitendrabaraiya

A proposal has not yet been provided

€277 EUR trong 10 ngày
(2 Đánh Giá)
1.8
ajeetinvis

I have worked on such projects which basically involved creating swarm mesh network. I have 3+yrs experience in Embedded system working in Mumbai, India.

€222 EUR trong 5 ngày
(1 Đánh Giá)
1.0
blue2sea

Dear Sir I can finish this task in 3 day. I look forward your response. Regards. Relevant Skills and Experience Firmware development Proposed Milestones €23 EUR - I want only 23$ for this task

€23 EUR trong 3 ngày
(0 Đánh Giá)
0.0
Cpawar06

i have good experience in Arduino. Relevant Skills and Experience Experience in embedded design & arduino. Proposed Milestones €166 EUR - software design

€166 EUR trong 5 ngày
(0 Đánh Giá)
0.0
€166 EUR trong 5 ngày
(0 Đánh Giá)
0.0