Small Camera (for video & pictures)

I would like a small digital video/still camera to be developed.

I would like the PCB height to not exceed 3.75 inches, the length around .75 inches, and the total width around half an inch (the camera can stick out slightly more if required). I have seen cameras circuits much smaller than this (2" x 5/8" x 7/16" ... battery not included), so it is definitely possible.

I have attached a pdf of the general layout & operation that I am currently imagining. The layout for both sides can change if discussed and agreed upon.

Total Scope:

1. design and layout of the board

2. development of embedded software (if required)

3. debugging and revision of the board

4. manufacturing of two boards placed within an agreed upon enclosure

I'm not in a huge hurry on this project, so you will not be rushed into completion. However, I would like to see some initiative taken immediately after selection. Priority given to freelancers demonstrating the necessary experience to deliver.

I will consider higher bids from candidates who can demonstrate being able to get the project done quickly and reliably.

The successful candidate will need to enter into an NDA and development agreement.

Kĩ thuật điện Điện tử Kĩ thuật PCB Layout

ID dự án: #1027609

Về dự án