PROBLEM: My car's ignition distributor cap is too tall and blocks a metal pipe connection (as shown in pictures). The attached pictures show the original distributor cap, Rotor mechanism that operates inside this cap, and the space constraints.
CHALLENGE: Design a car's ignition DISTRIBUTOR CAP that meets the following criteria:
1. Reconstruct the 3D laser scanned mesh (.obj file) of the original distributor cap and "reverse engineer" an accurately sized 3D model.
2. Maximum height from base of NEW design = 56mm
3. Manufacturer friendly design that minimizes production cost.
4. The final design file must be compatible with Solidworks software.
Attached is an example of the original distributor cap design. The 3 screw holes at the base must be in the same positions, so the only design feature that needs changing is the spark wire connectors. These 7 tubes protruding from the distributor cap need to face different directions so they do not contact the pipe as shown in the picture. Please, only bid on this project IF YOU KNOW HOW TO DESIGN a Distributor cap for manufacturing. Full payment sum will be sent to FreeLancer upon completion of the design that meets the above criteria.
If you are experienced using software like Rapidform XOR2 or XOR3, this should be quick and easy.