Nextion Project to add some code to existing HMI and add test run code to existing ESP32 for test.

Project Name: nextion code HMI to / from ESP32 send receive number data in WITS (ASCII) format.

I have the code for esp32 and HMI code for Nextion 7”

Requiring:

1. On Page 0. Code the hmi to show the demo data sent to Nextion and printed in proper places.

Make bigger data window to fit bigger number 9000.01 (I will run testing)

2. Print the values from esp32 by name 1 per 2 sec.

3. Run set_Test_gc_TG_dtg_Values() with random values 100.0 to 10,000.0

4. And sent it to Nextion Page 0

2. On Page 1; Program buttons on

2.1 Add Button…. Enter GC_Calibration_Value ..default 1%, 1% to 100% Percent

2.2 On touch call data entry keybdB and save the value in Calibr_Gas_C1_C5_Value

2.3 Send Calibr_Gas_C1_C5_Value to esp32 and store in eeprom

2.4

2.5 On Start Sycle Button Press : Make check if the Calibr_Gas_C1_C5_Value is less than 1.0 put note “ Enter Calibr_Gas_C1_C5_Value”

2.6

2.7 After press Button <Start Cycle> draw the value of f_gc_cc_sensor in wave form 1 window, 1 per 2 second. For 300 sec.

2.8 Stop after 300 sec and wait for manual edit (if any) and ration calculations.

2.9 Wait till save button pressed.

2.10 make send_data_calib_to_screen(); to place the values in the proper boxes. C1…%...ADC..Ratio

2.1 make random test data an print in according places.

2.2 Create and Add variables list

2.3 Variables list:

1. Time in Hr;min 18:30

2. Depth in Integer 12900 - Depth

3. Lag Depth int 11000 -LagDepth

4. TG – int 0-15000 tg_val_max

5. DTG- int 0-15000 dtg_val_max

6. C1 % 0.01 to 100% gc_c1_Max

7. C2 % 0.01 to 100% gc_c2_Max

8. C3 % 0.01 to 100% gc_c3_Max

9. C4 % 0.01 to 100% gc_c4_Max

10. C5 % 0.01 to 100% gc_c5_Max

Plot 20 values and scroll up by 1 line All, to be able t see last 20 records on 2 pages.

Lập trình C Kiểm tra phần mềm Phần mềm cài sẵn Xử lí sự cố

ID dự án: #34721685

Về dự án