National Instruments Continuity Testing
$250-750 USD
Thanh toán khi bàn giao
I am looking to have someone develop a LabView program for me to conduct testing on a simple unit. I have the following:
-PXIe-1082, 8-Slot 3U PXI Express
-PXIe-4080 High-Performance 6 1/2 Digit
-NI PXI-2575 196 ch Multiplexer
-LFH200 Connector to Bare Wire Switch Cable, 2 M
I need the following:
1). Loop back continuity test through a test cable on one end to modified ethernet, serial and JTAG cables on the other end.
2). Test for continuity, opens and shorts.
3). Measure DC voltage from JTAG cable and PMC voltages (+12, -12, 5, 3.3) from test cable.
4). Have a user interface to enter in Part Number and Serial Number.
5). Develop a test report output with Pass/Fail and readings.
ID dự án: #21102872
Về dự án
9 freelancer chào giá trung bình$609 cho công việc này
Hi I can understand your requirement. Do you any layout of the report like that you want to print? Does the voltage come from JTAG after any interval or continuously? Please confirm the above points so I can ask my o Thêm
Hi, I am expert in radar field. I've a lot of experience for 10+ years in Labview field. I'll satisfy you in all fields with radar part. If you send me your specification, I'll check, finish it and send the final produ Thêm
Hello. I am a senior Electronic Engineer and Microcontroller firmware developer. I have worked in firmware and embedded system developments for 8 years. I can develop the firmware of Arduino, STM32, ARM, DSP, FPGA and Thêm
Hi there, I have checked the details. I have rich experience with Electronics, LabVIEW. Please initiate the chat so we can discuss this job in detail. I am new to freelancer.com but I assure you that I can deliver you Thêm
I have used NI devices and labview to develop many functional tester and software for PCBA mass production test.